Filter
Top Products
6
PRIMUS THEATER PACK II
OPERATION
Surround Modes
When using the system in a Dolby
®
Digital or DTS
®
home theater
system, make sure all speakers are set to “Small”.
Some Dolby Digital-equipped receivers/processors offer different
setup options for each source or surround mode; e.g., CD-stereo,
videotape, Dolby Pro Logic.
®
In each case, follow your equip-
ment’s instructions to ensure that the subwoofer output is turned
on (if you are using a subwoofer) and that the speakers are set
to “Small”in each mode.
When using the Primus Theater Pack in a Dolby Pro Logic home
theater system, make sure the receiver’s center channel mode is
set to “Normal.”
The satellite and subwoofer enclosures may be cleaned using a
soft cloth to remove fingerprints or to wipe off dust.
The grilles may be gently vacuumed. Stains may be removed with
an aerosol cleaner, following its instructions. Do not use any
solvents on the grille.
All wiring connections should be inspected and cleaned or
remade periodically.The frequency of maintenance depends on
the metals involved in the connections, atmospheric conditions,
and other factors, but once per year is the minimum.
If a problem occurs, make sure that all connections are properly
made and clean. If a problem exists in one loudspeaker, reverse
the connection wires to the left and right system. If the problem
remains in the same speaker, then the fault is with the loud-
speaker. If the problem appears in the opposite speaker, the
cause is in another component or cable. In the event that your
subwoofer ever needs service, contact your local Infinity dealer
or distributor, or visit www.infinitysystems.com for a service
center near you.
MAINTENANCE AND SERVICE
Primus Theater PackII OM 10/2/06 10:05 AM Page 6