Filter
Top Products
4
PRIMUS THEATER PACK II
PLACEMENT
WALL-MOUNTING THE SATELLITES AND
CENTER CHANNEL
NOTE:The satellite speakers can be placed directly on a shelf, or
mounted on a wall using the built-in keyhole mount or optional
wall brackets.
Left and Right Front Channels
For left and right front channels, place one satellite to the left
and another to the right of the television, as shown in Figures 1
and 2. Since the speakers are magnetically shielded,you can
place them very close to the TV without worrying about the
magnetic field distorting the picture.
Center Channel
For the center channel, place the speaker directly on top of,
or below, your television. Use a shelf if the television does not
provide a stable platform.
Surround Channels
For left and right surround channels, place one speaker on the
left and another on the right, to the side of or slightly behind the
listening area.The surround speakers should be mounted at a
height of between 4 feet and 7 feet.
Optional Subwoofer
Adding an Infinity powered subwoofer to the Primus Theater
Pack II will add the low-frequency information found in many
recordings. Infinity manufactures several powered subwoofers
that will deliver the impact and realism of today’s music and
movie soundtracks. Consult your Infinity dealer for help in
determining which subwoofer is best for you. If you already
own a subwoofer, consult the subwoofer’s manual for proper
installation and connection instructions.
The Primus Theater Pack II satellites and center channel are
designed to mount directly to a wall. Each satellite speaker has two
keyholes on the back. Each speaker will require two (2) 1-1/2"
#10 wood screws fastened to a wall stud. If a wall stud is
unavailable, install anchors appropriate for 1-1/2"#10 screws.
NOTE:The customer is responsible for the correct selection
and use of mounting hardware (available through hardware
stores) that will ensure the proper and safe wall-mounting of
the speakers.
Step 1.
Mark the position on the wall where you would like to place the
mounting screws.
Step 2.
Fasten two 1-1/2"#10 wood screws to the wall using the markings
placed in Step 1 as your guide. Leave an 11/16" space between
the wall and screwhead. If a wall stud is not available,
use appropriate anchors.
Step 3.
Place the speaker on the wall by aligning the keyholes on the back
of the speaker to the screwheads on the wall. Once positioned
properly, the speaker should slide down slightly and then
become secure.
Each satellite also allows for the use of third-party wall brackets
using the 1/4"-20 threaded insert located beneath the keyhole
mount. Consult the wall-bracket manufacturer for selection of
proper brackets.ker on the wall by aligning the keyhole on the back
of the speaker to the screwhead on the wall. Once positioned
properly, the speaker should slide down slightly and become
secure.
– +
Figure 3.
1/4"-20
Threaded
insert
(remove cover)
(satellites only)
Keyhole mounts
Primus Theater PackII OM 10/2/06 10:05 AM Page 4