Infinity Infinity Compact Powered Subwoofer Speaker System User Manual


 
4
Cascade Model Twelve
Power On
P
lug your subwoofer’s AC cord into a wall outlet.Do not use the
outlets on the back of the receiver.
Initially set the Subwoofer Level (Volume) Control
§
to the
“min”position.
T
urn on your sub by pressing the Power Switch
¡
o
n the
rear panel.
Auto On/Standby
With the Power Switch
¡
in the ON position, the Power
Indicator LED
¢
will remain backlit in red or green to
indicate the On/Standby mode of the subwoofer.
RED = STANDBY (No signal detected,Amp Off)
GREEN = ON (Signal detected,Amp On)
The subwoofer will automatically enter the Standby mode after
approximately 10 minutes when no signal is detected from your
system.The subwoofer will then power ON instantly when a
signal is detected. During periods of normal use, the Power
Switch
¡
can be left on.You may turn off the Power Switch
¡
f
or extended periods of nonoperation, e.g., when you are away
on vacation.
Adjust Gain
Turn on your entire audio system and start a CD or movie
soundtrack at a moderate level.Turn up the Subwoofer Level
(Volume) Control
§
about half way. If no sound emanates from
the subwoofer, check the AC-line cord and input cables. Are the
connectors on the cables making proper contact? Is the AC
plug connected to a “live”receptacle? Has the Power Switch
¡
been pressed to the “On”position? Once you have confirmed that
the subwoofer is active, proceed by playing a CD, record or
cassette. Use a selection that has ample bass information.
Set the overall volume control of the preamplifier or stereo to a
comf
or
table le
vel. Adjust the Subwoofer Level (Volume) Control
§
until you obtain a pleasing blend of bass.Bass response should
not overpower the room but rather be adjusted so there is a
harmonious blend across the entire musical range. Many users
ha
v
e a
tendency to set the subwoofer volume too loud,
adhering to the belief that a subwoofer is there to produce lots
of bass.This is not entirely true.A subwoofer is there to enhance
bass, extending the response of the entire system so the bass
can be f
elt as well as hear
d. However, overall balance must
be maintained or the music will not sound natural. An
experienced listener will set the volume of the subwoofer so
its impact on bass response is always there but never obtrusive.
OPERATION
C
rossover Adjustments
NOTE: This control will have no effect if the Normal/LFE Selector
Switch
is set to “LFE.”If you have a Dolby Digital or DTS
processor/receiver, the Crossover Frequency is set by the
processor/receiver. Consult your owner’s manual to learn how
to view or change this setting.
The Crossover Adjustment Control
determines the highest
frequency at which the subwoofer reproduces sounds. If your main
s
peakers can comfortably reproduce some low-frequency sounds,
set this control to a lower frequency setting, between 50Hz
a
nd 100Hz.This will concentrate the subwoofer’s efforts on the
ultradeep bass sounds required by today’s films and music. If you
a
re using smaller bookshelf speakers that do not extend to the
lower bass frequencies, set the Crossover Adjustment Control to
a higher setting, between 120Hz and 150Hz.
Phase Control
The Phase Switch determines whether the subwoofer
speaker’s piston-like action moves in and out with the main
speakers, 0,˚or opposite the main speakers,180˚.Proper phase
adjustment depends on several variables such as room size,
subwoofer placement and listener position.Adjust the phase
switch to maximize bass output at the listening position.
Cascade 12 OM 9/21/05 5:03 PM Page 7