Filter
Top Products
3
Cascade Model Twelve
CONNECTIONS
If you have a Dolby* Digital or DTS
®
receiver/processor
w
ith a low-frequency-effects (LFE) output:
• Set Normal/LFE Switch to LFE.
NOTE: In this case, you do not need to use a Y connector. Simply
connect the LFE output on your receiver/processor to either the
left or right input on the subwoofer.
SUBWOOFER OR
L
FE OUTPUT
Line In
Line Out
150
Max
Level
C
rossover
[Hz]
50
Min
LFE
Input
P
hase
N
ormal
O
ff
O
n
LFE
G
reen:On
Red:Standby
Model Twelve
The Cascade Model Twelve also
includes a set of line outputs.These
outputs allow you to “daisy-chain”
one Model Twelve to multiple Model
Twelve subwoofers. Simply connect
the first subwoofer as described
above and then run a subwoofer
cable from the line output(s) to the
line input(s) on the next sub.
NOTE:This line output is before the
R.A.B.O.S. circuit. Each subwoofer’s
R.A.B.O.S. controls must be
individually adjusted during the
R.A.B.O.S. setup.
I
f your receiver/processor has subwoofer
outputs for the left and right channels:
• Set Normal/LFE Switch to Normal.
NOTE: Some receivers have a single subwoofer output (do not
confuse this with a single LFE output as described to the left).
In that case, it is recommended that you use a Y connector (not
included) to maximize performance.
L
ine In
L
ine Out
150
Max
Level
C
rossover
[
Hz]
50
Min
L
FE
Input
P
hase
Normal
O
ff
O
n
LFE
Green:On
Red:Standby
M
odel Twelve
SUBWOOFER OR
LFE OUTPUT
L
ine In
Line Out
LFE
Input
G
reen: On
R
ed: Standby
Model Twelve
L
ine In
Line Out
LFE
Input
G
reen: On
R
ed: Standby
Model Twelve
Line In
Line Out
L
FE
Input
Green: On
Red: Standby
Model Twelve
Line In
Line Out
L
FE
Input
Green: On
Red: Standby
Model Twelve
OR
Cascade 12 OM 9/21/05 5:03 PM Page 6