Filter
Top Products
6
CAS 3.1/CAS 2.1
Step 4
The CAS mounting frame has a series of spring-loaded clamps
around its perimeter.These are designed to fold shut as you push
the mounting frame into the hole and spring open once inside,
thus holding the mounting frame in the wall. Insert the mounting
frame into the cutout, making sure that you run the speaker wire
in through the rear opening. Starting from the lower right-hand
corner and working in a counterclockwise fashion, hand-tighten
each of the 12 clamp screws (ONLY until almost snug). If needed,
adjust the mounting frame so it is level and centered in the
cutout. Go around once more and hand-tighten each screw as
needed. Before proceeding to Step 5, verify that each of the
clamp screws is tight.
Note how the clamp will push closed while being inserted into
the hole in the wall and spring open again once past the wall.
Tightening the screw snugly will hold the mounting frame to
the wall.
WALL
3.
WALL
2.
WALL
CLAMP
SCREW
1.
Note how the clamp
springs open
CLAMP
SPEAKER WIRES
SPEAKER WIRES
CLAMP
Note how the clamp
springs open
WALL
WALL
WALL
CLAMP
SCREW