Filter
Top Products
Basslink/Basslink X
TROUBLESHOOTING
• PROBLEM:
POWER LED not lit.
CAUSES and SOLUTIONS:
1. Fuse is blown and needs replacement.
2. Head unit not functioning properly. Check
remote voltage, and power, ground or
remote connections.
• PROBLEM:
POWER LED is lit but there is no bass.
CAUSES and SOLUTIONS:
1. Inputs are not connected. Check connections.
2. Head-unit fader control is not set properly.
Adjust head-unit fader control to feed audio
signals to BassLink.
• PROBLEM:
BassLink sounds muddy or distorted.
CAUSES and SOLUTIONS:
1. Gain is set too high and SERVO LED is lit
constantly. Readjust GAIN control (see
Tuning BassLink on the previous page).
2. Bass is set too high. Readjust BASS BOOST
control (see Tuning BassLink on the previous
page).
3. Head-unit output is distorted or blown. See
your authorized Infinity car audio dealer.
• PROBLEM:
No output from BassLink when head-unit
fader control set to front or rear (in a 4-channel
connection).
CAUSE and SOLUTION:
Input connections are improperly wired. Verify all
connections (see Applications section)
APPLICABLE TO BASSLINK WITH LEVEL
CONTROL JACK AND BASSLINK X ONLY:
• PROBLEM:
BassLink turns on before head unit is completely on
and produces a “thump” sound.
CAUSE and SOLUTION:
For speaker-level connections, head unit is
producing a false turn-on signal. On BassLink’s
side panel, slide AUTO TURN-ON to OFF.
• PROBLEM:
BassLink’s POWER LED remains on after head
unit is turned off.
CAUSE and SOLUTION:
For speaker-level connections, this is normal
operation when AUTO TURN-ON is set to ON.
BassLink will remain on another 5 to 10 minutes
after sensing that audio signals are not present
before shutting down. If you prefer immediate shut-
down, set AUTO TURN-OFF to OFF.
7