2
INSTALLATION WARNINGS
•
Always wear protective eyewear when using
tools.
•
Turn off the audio system and other electrical
devices before you start. Disconnect the (–)
negative lead from your boat’s battery and/or
turn off the battery switch if you have a
multiple battery setup.
•
Check clearances on both sides of a planned
mounting surface before drilling any holes or
installing any screws. Remember that the
screws can extend behind the surface and
could puncture the boat’s hull.
•
At the installation sites, locate and make a note
of all fuel lines, steering cables, and electrical
wiring. Use extreme caution when cutting or
drilling in and around these areas.
•
Before drilling or cutting holes, use a utility
knife to remove unwanted fabric or vinyl to
keep material from snagging in a drill bit or
mounting screws.
•
When routing cables, keep input-signal cables
away from power cables and speaker wires.
•
When making connections, make certain they
are secure and properly insulated.
INTRODUCTION
WARNING!
Loud music can cause permanent damage to your
hearing. We recommend listening to your system
at moderate volume levels while driving your
boat. Infinity accepts no liabilities for hearing loss,
bodily harm or property damage resulting from
the use or misuse of our products.
IMPORTANT
To get the best performance from your Infinity
Marine Audio products, we strongly recommend
that installation be entrusted to a qualified
professional. Although these instructions explain
how to install the Wakeboard Tower System
in a general sense, they do not show specific
installation methods that may be required for
your particular application. If you do not have
the necessary tools or experience, do not attempt
the installation yourself. Instead, please ask your
authorized Infinity car/marine audio dealer about
professional installation.
CLEANING AND PRECAUTIONS
Although the 6000m speaker pods are water-
and salt-spray-resistant, keep in mind that the
speakers are exposed and may be damaged
during washdowns. Use only a damp cloth to
wipe the speakers down. DO NOT spray water,
or any liquids, directly at the speakers. High
pressure may damage the speakers, especially
the tweeters. The 6100m and 2100m amplifiers
should be installed where they will not come in
contact with water or other liquids. The amplifier
could be damaged during washdowns.
DESCRIPTION
•
The 6000m Wakeboard Tower Speakers are
constructed of weatherproof cast-polymer,
and have passed our most stringent tests to
ensure that you get only the best quality
product. The 6100m uses two active 6-1/2"
polypropylene speakers with a 1" CMMD
™
tweeter. The cast-aluminum mounting
brackets are adjustable to fit almost any
commonly available tube (1-1/2" to 2-1/2")
and can be configured for surface mounting.
•
The 6100m Wakeboard Tower System is an
all-in-one speaker system for your boat. The
6100m includes two all-weather speaker pods
(6000m) with all of the mounting hardware,
and a dedicated 2-channel amplifier with an
integrated microphone and controls. This
system allows you to listen to music while
riding, and allows the driver to communicate
back to the rider.
•
The 2100m Marine Amplifier is a stand-alone
amplifier that can be used with or without the
6100m system. This amplifier can be used to
supply power to interior speakers or additional
6000m wakeboard tower speakers.