Filter
Top Products
GETTING STARTED
• This system is designed to operate on AC100V~240V 60/50Hz house current only.
• Connecting this system to any other power source may cause damage to the system and such
damage is not covered by your warranty.
• Main plug is used as the disconnect device, the disconnect device shall remain readily operable.
Power Source
Note:
The system has an AC plug and will only t into matching AC
outlets. This is a safety feature to reduce the possibility of electric
shock. If the plug will not t in your AC outlets, you should have
the outlet changed by a qualied, licensed electrician. Do not use
an adapter to make the plug t into your outlet. This defeats the
safety feature and could expose you to electric shock.
This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving when
you operate the controls. These ‘feet’ are made from non-migrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However certain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to
soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your
furniture we strongly recommend that you purchase small self-adhesive felt pads, available at
hardware stores and home improvement centers everywhere, and apply these pads to the bottom
of the rubber ‘feet’ before you place the product on ne wooden furniture.
Protect your Furniture
AC Plug AC Oulet
The remote control battery has been previously installed and ready for operation for the rst time
use. When the remote control stops functioning, replace the battery with a new one. To do so,
locate the battery compartment and follow the steps below:
Installing the Remote Control Battery
GETTING STARTED
1. Slide out the battery holder from the remote
control case.
2. Insert a “CR2025” 3V lithium battery making
certain to follow the correct polarity. Observe
the corresponding symbols (+/–).
3. Secure battery and push the battery holder
back into the remote control until it is
fully inserted.
Battery
door latch
A
B
iLuv | 4iMM173 | V12M12_IM_EN_050820093 | iLuv