Filter
Top Products
Noise-Canceling Headset w/ Bluetooth wireless technology V10M10_IM_EN_12072006
www.i-Luv.com
- 12 -
OPERATING INSTRUCTIONS
Pairing i913 with your Mobile Phone or Audio Device
Before using this headset, make sure that it is paired with a mobile phone and audio
devices with Bluetooth wireless technology. To pair with such a device, follow the
instructions below:
1. Please make sure the headset is at standby
mode. If i913 is currently turned on then press
the Multi-Function button for approximately
five (5) seconds. There will be a high-pitched
beep with red light flashes about 4 times and
headset will go into standby mode.
2. Press and hold the Multi-function button for
approximately five (5) seconds until the red
and blue lights blink alternately around the
button. The headset is now ready for pairing.
(Note: Pressing the Multi-function button
longer than five (5) seconds will turn off the
headset. If this fails, turn off the headset and
turn it on again by holding the Multi-Function
button for five (5) seconds for pairing mode)
3. Set your mobile phone or audio device to its pairing mode (phones and audio devices
with Bluetooth wireless technology will have their own pairing instructions. See
owner’s manual of the phone or device for these instructions).
4. Place the mobile phone or audio
device and the i913 close
together during pairing. The
mobile phone and most audio
devices will detect i913 and
identify it, displaying the model
number i913.
5. Once the i913 has been identified, confirm as per the
instructions on the device. You will be required to
enter a password on the next screen.