Ear Clip Headset w/ Bluetooth wireless technology V10M10_IM_EN_11082006
www.i-Luv.com
-9 -
OPERATING INSTRUCTIONS
Pairing i212 with your Mobile Phone or Audio Device
Before using this headset, make sure that it is paired with a mobile phone and audio
devices with Bluetooth wireless technology. To pair with such a device, follow the
instructions below:
1. Please make sure the headset is turned off.
To Turn off i212 if it is currently turned on
then press the Multi-Function button for
approximately five (5) seconds. There will be
a high-pitched beep with red light flashes
about 4 times and headset will be off.
2. Press and hold the Multi-function
button for approximately five (5) seconds
until the red and blue lights blink
alternately around the button. The
headset is now ready for pairing. (Note:
Pressing the Multi-function button
longer than five (5) seconds will turn off
the headset. If this fails, then turn off the headset and turn it on again by holding the
Multi-Function button for five (5)
sec for pairing mode)
3. Set your mobile phone or audio
device to its pairing mode (phones
and audio devices with Bluetooth
wireless technology will have their
own pairing instructions. See
owner’s manual of the phone or
device for these instructions).
4. Place the mobile phone or audio device and the i212 close together during pairing.
The mobile phone and most audio devices will detect i212 and identify it, displaying
the model number i212.
5. Once the i212 has been identified, confirm as per the
instructions on the device. You will be required to enter a
password on the next screen.