Icom IC F121S Stereo System User Manual


 
5 - 1
SECTION 5 ADJUSTMENT PROCEDURES
+
Audio generator
300 Hz to 3 kHz
AC
millivoltmeter
MICE
MIC
PTT
PTT switch
PTTE
Add a jumper wire here
*OPC-1122 (JIG CABLE)
Electrolytic
capacitor
47 µF
OPC-1122
(Cloning cable)
5-1 PREPARATION
When you adjust the contents on pages 5-5 and 5-6, SOFT-
WARE ADJUSTMENT, the optional CS-F100S ADJ ADJUST-
MENT SOFTWARE (Rev. 1.0 or later), *OPC-1122 JIG CABLE
(modified OPC-1122 CLONING CABLE; see illustration below)
are required.
SYSTEM REQUIREMENTS
IBM PC compatible computer with an RS -232C serial port
(38400 bps or faster).
Microsoft Windows 95/98 or Windows ME
Intel Pentium 100 MHz processor or faster
At least 16 MB RAM and 10 MB of hard disk space
640×480 pixel display (800×600 pixel display recommend-
ed)
ADJUSTMENT SOFTWARE INSTALLATION
q Boot up Windows.
- Quit all applications when Windows is running.
w Insert the CS-F100Sinto the appropriate CD drive.
e Select Runfrom the [Start] menu.
r Type the setup program name using the full path name,
then push [Enter] key.
(ex. D:\CSF100SADJ\Setup.exe)
t Follow the prompts.
y Program group CS-F100S ADJ appears in the
Programsfolder of the [Start] menu.
STARTING SOFTWARE ADJUSTMENT
q Connect IC-F110S and PC with *OPC-1122 JIG CABLE.
w Turn the transceiver power ON.
e Boot up Windows, and click the program group CS-
F100S ADJ in the Programs folder of the [Start] menu,
then CS-F100S ADJs window appears.
r Click Connect on the CS-F100s window, then appears
IC-F110Ss up-to-date condition.
t Set or modify adjustment data as desired.
IBM is a registered trademark of International Bussiness
Machines Corporation in the U.S.A. and other countries.
Microsoft and Windows are registered trademarks of
Microsoft Corporation in the U.S.A. and other countries.
Screen shots produced with permission from Microsoft
Corporation. All other products or brands are registered
trademarks or trademarks of their respective holders.