Filter
Top Products
2
TubeTools
®
Version 1.1 11/2006
UNITED STATES
IMPORTANT SAFETY INSTRUCTIONS
READ BEFORE CONNECTING!
• Read all of these instructions!
• Save these instructions for later use!
• Follow all warnings and instructions marked on the product!
• Do not use this product near water, i.e. bathtub, sink, swimming pool,
wet basement, etc.
• Do not place this product on an unstable cart, stand or table. The
product may fall, causing serious damage to the product or to persons!
• Slots and openings in the cabinet and the back or bottom are provided
for ventilation; to ensure reliable operation of the product and to protect
it from overheating, these openings must not be blocked or covered.
This product should not be placed in a built-in installation unless
proper ventilation is provided.
• This product should not be placed near a source of heat such as a stove,
radiator, or another heat producing amplifier.
• Use only the supplied power supply or power cord. If you are not sure of
the type of power available, consult your dealer or local power company.
• Do not allow anything to rest on the power cord. Do not locate this
product where persons will walk on the cord.
• Never break off the ground pin on the power supply cord.
• Power supply cords should always be handled carefully. Periodically
check cords for cuts or sign of stress, especially at the plug and the point
where the cord exits the unit.
• The power supply cord should be unplugged when the unit is to be
unused for long periods of time.
• If this product is to be mounted in an equipment rack, rear support
should be provided.
• This product should be used only with a cart or stand that is
recommended by Hughes & Kettner.
• Never push objects of any kind into this product through cabinet slots
as they may touch dangerous voltage points or short out parts that
could result in risk of fire or electric shock. Never spill liquid of any
kind on the product.
• Do not attempt to service this product yourself, as opening or removing
covers may expose you to dangerous voltage points or other risks. Refer
all servicing to qualified service personnel.
• Clean only with dry cloth.
• Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The
wide blade or the third prong are provided for the safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement
of the obsolete outlet.
• Place the product always in a way that the mains switch is easily
accessible.
• Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
• When the power cord or plug is damaged or frayed.
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally when the operating
instructions are followed.
• If the product has been dropped or the cabinet has been damaged.
• If the product exhibits a distinct change in performance, indicating a
need of service!
• Adjust only these controls that are covered by the operating instructions
since improper adjustment of other controls may result in damage and
will often require exten sive work by a qualified technician to restore the
product to normal operation.
• Exposure to extremely high noise levels may cause a permanent hearing
loss.
• Individuals vary considerably in susceptibility to noise induced
hearing loss, but nearly everyone will lose some hearing if exposed to
sufficiently intense noise for a sufficient time. The U.S. Government´s
Occupational Safety and Health Administration (OSHA) has specified
the following permissible noise level exposures:
Duration per day in hours Sound Level dBA, slow response
8 90
6 92
4 95
3 97
2 100
1½ 102
1 105
½ 110
¼ or less 115
• According to OSHA, any exposure in excess of the above permissible
limits could result in some hearing loss.
• Ear plug protectors in the ear canals or over the ears must be worn
when operating this amplification system in order to prevent a
permanent hearing loss if exposure is in excess of the limits as set
forth above. To ensure against potentially dangerous exposure to high
sound pressure levels, it is recommended that all persons exposed to
equipment capable of producing high sound pressure levels such as this
amplification system be protected by hearing protectors while this unit
is in operation.
• Fuses: Replace with IEC 127 (5 x 20 mms) type and rated fuse for best
performance only
TO PREVENT THE RISK OF FIRE AND SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN. DO
NOT OPEN CASE; NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ENGLISH
IMPORTANT ADVICE ON SAFETY! PLEASE
READ BEFORE USE AND KEEP FOR LATER
USE!
• The unit has been built by Hughes & Kettner in accordance with IEC
60065 and left the factory in safe working order. To maintain this
condition and ensure non-risk operation, the user must follow the advice
and warning comments found in the operating instructions. The unit
conforms to Protection Class 1 (protectively earthed).
HUGHES & KETTNER ONLY GUARANTEES THE SAFETY,
RELIABILITY AND EFFICIENCY OF THE UNIT IF:
• Assembly, extension, re-adjustment, modifications or repairs are carried
out by Hughes & Kettner or by persons authorized to do so.
• The electrical installation of the relevant area complies with the
requirements of IEC (ANSI) specifications.
• The unit is used in accordance with the operating instructions.
• The unit is regularly checked and tested for electrical safety by a
competent technician.