Filter
Top Products
15
This projector is equipped with NETWORK BRIDGE function.
When the projector connects to the computer by wired or wireles LAN
communicaton, an external device that is connected with this projector by RS-
232C communication can be controlled from the computer as a network terminal.
For details, see the 6. Network Bridge function in the Network Guide.
Network Bridge Communication
LAN
CONTROL
LAN
RS-232C
LAN cable
(CAT-5 or greater)
NOTE • If data is transferred via wireless and wired LAN at the same time,
the projector may not be able to process the data correctly.
Connection
1.
If you use wired LAN, connect the computer's LAN port and the projector's LAN
port with a LAN cable. Use the cable that fulfills the specification shown in figure.
If you use wireless LAN, insert the USB wireless adapter into the projector's LAN port.
2.
Connect the projector's CONTROL port and the RS-232C port of the devices
that you want to control with a RS-232C cable.
3.
Turn the computer on, and after the computer has started up turn the
projector on.
4.
Set the COMMUNICATION TYPE to NETWORK BRIDGE. (OPTION menu
- SERVICE - COMMUNICATION in the Operating Guide)
Network Bridge Communication