Filter
Top Products
CONNECTING MICROPHONES TO THE XLR INPUT
If you use a stereo microphone, connect it to the XLR
mic inputs. If you use a single microphone, connect it to
either the left or right XLR mic input. (See page 15 for
further information about recording from a microphone
and page 17 for information about mono recording.) If
you use a microphone that requires phantom power, set
phantom mode to ‘ON’ by accessing the
INPUT menu
(see page 15).
ANALOG SOURCE RECORDING VIA THE XLR INPUT
SENDING ANALOG AUDIO TO EXTERNAL ANALOG
EQUIPMENT
CONNECTING TO DIGITAL EQUIPMENT VIA
COAXIAL OR OPTICAL
Digital source recording via COAXIAL or OPTICAL inputs.
SENDING DIGITAL AUDIO TO EXTERNAL DIGITAL
EQUIPMENT VIA COAXIAL OR OPTICAL OUTPUTS
NOTE – Ensure the digital output is turned ‘ON’ – see
page 24 for details.
CONNECTING WITH A COMPUTER VIA THE USB
INTERFACE
REMOTE CONTROL
The pin layout for the parallel remote connector is as
follows:
Parallel remote connector – pin configuration of Mini
DIN remote control:
MIC/LINE IN (L) MIC (L)
MIC/LINE IN (R) MIC (R)
MIC/LINE IN (L) LINE OUT (L)
MIC/LINE IN (R) LINE OUT (R)
LINE OUT (L) LINE IN (L)
LINE OUT (R) LINE IN (R)
DIGITAL IN DIGITAL OUT
(COAXIAL OR OPTICAL) (COAXIAL OR OPTICAL)
ONE COAXIAL OR
OPTICAL CABLE
(Both inputs indicated
with arrows)
PREPARATION cont.
PORTADISC MDP500 MiniDisc Recorder
DIGITAL OUT DIGITAL IN
(COAXIAL OR OPTICAL) (COAXIAL OR OPTICAL)
USB COMPUTER
USB PORT
USB CABLE
ONE COAXIAL OR
OPTICAL CABLE
(Both outputs
indicated with arrows)
12
CONNECTIONS
PDISC_OP.QXD 6/11/00 12:43 pm Page 13