Filter
Top Products
Online spare memory configuration
Online spare memory configurationOnline spare memory configuration
Online spare memory configuration
Online spare FBDIMM configuration requirements (in addition to general configuration requirements):
When only bank A is being used, it must be fully populated with dual-rank FBDIMMs.
If banks A and C are being used, they must be fully populated.
If installed, bank A and bank C must contain FBDIMMs with identical part numbers.
If installed, bank B and bank D must also contain FBDIMMs with identical part numbers.
In online spare mode, FBDIMMs must be populated as specified in the following table:
Configuration
ConfigurationConfiguration
Configuration
Branch 0
Branch 0Branch 0
Branch 0
Bank A
Bank ABank A
Bank A
1A and 3A
1A and 3A1A and 3A
1A and 3A
Branch 0
Branch 0Branch 0
Branch 0
Bank C
Bank CBank C
Bank C
2C and 4C
2C and 4C2C and 4C
2C and 4C
Branch 1
Branch 1Branch 1
Branch 1
Bank B
Bank BBank B
Bank B
5B and 7B
5B and 7B5B and 7B
5B and 7B
Branch 1
Branch 1Branch 1
Branch 1
Bank D
Bank DBank D
Bank D
6D and 8D
6D and 8D6D and 8D
6D and 8D
1
*
X
- - -
2
X X
- -
3
X X X X
*
NOTE:
NOTE:NOTE:
NOTE:
Configuration 1 is only supported if using bank A, populated with dual-rank FBDIMMs. All FBDIMMs 1GB and above are
dual-rank.
After installing FBDIMMs, use RBSU to configure the system for online spare memory support ("Configuring online spare memory" on
page 57).
Mirrored memory configuration
Mirrored memory configurationMirrored memory configuration
Mirrored memory configuration
Mirrored memory FBDIMM configuration requirements (in addition to general configuration requirements):
Banks A and B must be fully populated.
Bank A and bank B must contain FBDIMMs with identical part numbers. If installed, bank C and bank D must also contain
FBDIMMs with identical part numbers.
When using mirrored memory mode, FBDIMMs must be populated as specified in the following table:
Configuration
ConfigurationConfiguration
Configuration
Bank A
Bank ABank A
Bank A
1A and 3A
1A and 3A1A and 3A
1A and 3A
Bank B
Bank BBank B
Bank B
5B and 7B
5B and 7B5B and 7B
5B and 7B
Bank C
Bank CBank C
Bank C
2C and 4C
2C and 4C2C and 4C
2C and 4C
Bank D
Bank DBank D
Bank D
6D and 8D
6D and 8D6D and 8D
6D and 8D
1
X X
- -
2
X X X X
NOTE:
NOTE:NOTE:
NOTE:
After installing FBDIMMs, use RBSU to configure the system for mirrored memory support ("Configuring mirrored memory" on
page 57).
QuickSpecs
HP ProLiant DL380 Generation 5 (G5)
HP ProLiant DL380 Generation 5 (G5)HP ProLiant DL380 Generation 5 (G5)
HP ProLiant DL380 Generation 5 (G5)
Memory
DA - 12477 Worldwide — Version 14 — February 12, 2007
Page 35