Heath Zenith 6022 Stereo Receiver User Manual


 
3598-1108-05
Channel Settings
Note: Most installations will not require you to change any of the dip
switches on your plug-in module or remote control.
The remote control and outdoor
module communicate by using chan-
nels that can be changed by sliding
dip switches into the ON or OFF [on
some switches the numbers 1 (ON)
and/or 0 (OFF) are used] position on
both the remote control and outdoor
module. The channel is factory set;
however, there are 3 switches (8
selectable channels) that allow you
to expand your system and prevent
outside interference. Other wireless
products may cause interference and
the system may not function properly.
Follow the instructions below for set-
ting a new channel.
1. Open the cases and locate dip switches on both the remote control and
outdoor module (see Figure 5).
2. The remote control and outdoor module both have two positions (ON and
OFF) on each of the four dip switches. Dip switches 1 through 3 are used
for setting the channel. Use the table below to set channel 2 after setting
channel 1. Note: The channels must be programmed according to the table
below for all 4 functions of the remote control to work properly. The receiver(s)
must match the code settings for channel 1. Use the table below to set the
corresponding code for channel 2.
3. To change the channel, slide dip switches to ON or OFF as needed. It is
recommended to only change one dip switch at a time and then check to see
if the system is functioning properly. Note: Dip switches in positions 1 through
3 must be in the exact same
conguration on both the remote
control and outdoor module for
this system to function properly.
O
N
1
2
3
4
Access
Door
Dip Switches - Shown
in the OFF Position
(Factory Default)
Keyholes
ON DIP
1 2 3 4
ON DIP
1 2 3 4
Figure 5
ON
1 2 3
4
Channel Setting Codes
Channel 1 Transmitter Channel 2
and Receiver(s) Transmitter
0000 0001
0010 0011
0100 0101
0110 0111
1000 1001
1010 1011
1100 1101
1110 1111
0 = OFF 1 = ON