Heath Zenith 6022 Stereo Receiver User Manual


 
2 598-1108-05
Precautions When Using
Outdoor Module
• The module must be oriented with the
power outlet down to prevent rain from entering the
unit (see Figure 2).
• The module must be located below the wall outlet as
shown. This is to prevent rain from running down the
cord into the wall outlet.
Note: The National Electrical Code and Canadian
Electrical Code (and most local codes) require that
outside outlets be protected by a Ground Fault Inter-
rupter (GFI).
Car Visor Clip
The remote control is equipped with a removable car visor clip for added con-
venience. The car visor clip may be removed to allow the remote to lie at on
table tops or other horizontal surfaces.
1. Attach car visor clip to car visor as shown in Figure 3.
2. To remove car visor clip. Insert a small at-head screw driver into slot on
back of remote. Gently push portion of clip inside of remote with screwdriver
while pulling clip out of remote from top (see Figure 4).
Power Outlets
Keyholes to
Hang Unit
Figure 2
Figure 3 Figure 4
Car Visor
Remote
Control
Visor Clip
Screwdriver
4. Plug in devices you wish to control.
Caution: Do not exceed the maximum load limits listed in Specications
section (see page 4).
5. Check operation. Place hand over light sensor cover. The unit should switch
on. To check remote operation, toggle left switch to manual. Toggle ON/OFF
switch.
6. Remote Control Functions.
Automatic Mode: Toggle left switch to automatic to allow switched devices
to come on at dusk and turn off at dawn. This is the default mode when rst
powered up or after power outage.
Manual Mode: Toggle left switch to manual to allow operator to manually
switch devices on and off. Use right toggle to switch devices on and off.
Note: LED will light when toggle switches
are pushed.