Harman-Kardon HK 3380 Stereo Receiver User Manual


 
REAR-PANEL CONNECTIONS 9
REAR-PANEL CONNECTIONS
¤ Subwoofer Out: Connect these jacks to the
line-level inputs of a powered subwoofer. If an external
subwoofer amplifier is used, connect these jacks to
the subwoofer amplifier inputs.When a single, mono
subwoofer is used, or if the subwoofer or its amplifier
has only a single line-level input jack, make the
connection to the bottom jack on the HK 3380.
Speaker 1 Terminals: Connect these terminals
to the appropriate terminals on your speakers.
Speaker 2 Terminals: Connect these terminals
to the appropriate terminals on your speakers.
Accessory Outlets: These outlets may be used
to power low-current-draw devices such as CD players
or cassette decks.The power to these outlets remains
on as long as the receiver itself is on.When the
receiver is placed in the Standby mode, power to
these outlets is removed.
NOTE: The power consumption of the devices
plugged into these outlets should not exceed
100 watts.
Power Cable: Connect the AC plug to a non-
switched AC wall output.
Remote IR Out: This connection permits the IR
sensor in the receiver to serve other remote-controlled
devices. Connect this jack to the “IR In” jack on
Harman Kardon (or other compatible) equipment.
° Remote IR In: If the HK 3380’s front-panel
IR sensor is blocked due to cabinet doors or other
obstructions,an external IR sensor may be used.
Connect the output of the sensor to this jack.
· Video Monitor Output: Connect this jack to the
composite video input of your TV or video display
device. Doing so will enable you to view the video
signal of a properly connected video source device,
when that source input is selected.When an audio-
only source is selected, the
Video Monitor Output
· will not transmit a video signal.
a AM Antenna: Connect the AM loop antenna
supplied with the receiver to these terminals. If an
external AM antenna is used, make connections to
the
AM and GND terminals in accordance with the
instructions supplied with the antenna.
b FM Antenna: Connect an indoor or external FM
antenna to this terminal.