Filter
Top Products
9
Alarm Operation
Setting the alarm time
- Set the TIME SET switch (9) to ALARM position. The actual time indication
is faded out.
- Press button HOUR (13) until the alarm hour is reached. For exact time,
press button MINUTE (11) until the correct alarm time is shown.
- Set the TIME SET switch (9) back to LOCK position. The actual time
indication returns.
Note:
The set alarm time may be checked by pressing button RECALL (2).
Alarm by radio
Slide switch POWER FUNCTION (1) to ON, tune in the desired station and
volume and then slide switch POWER FUNCTION (1) to position AUTO. In this
manner, the set is turned off again and switched over the alarm time. The
ALARM indicator AUTO (3D) lights.
As soon as the alarm time has been reached, the unit switches on
automatically and wakes you with the programme of the tuned-in station.
Approximately 59 minutes later, the unit switches off again automatically.
If you wish to listen to the radio for more than 59 minutes, slide the switch
POWER FUNCTION (1) to position ON; should you wish to switch off the set
after being roused, press the button (2). This will turn the radio off for 24
hours, till the wake up time on the following day.
Alarm by Buzzer sound
Set switch POWER FUNCTION (1) to position HWS (Humane Wake System)
(the ALARM indicator HWS (SNZ)(3D) lights). At the selected alarm time the
unit switches on automatically and wakes you with buzzer sound.
The buzzer sound starts very low and slowly gets louder and louder. After
about one minute the buzzer sound stops. The alarm will be repeated at an
interval of approx. 4 minutes up to 5 times. So you get waked up very gentle
and sure.
To turn off the buzzer simply press the STOP button (2). (The radio will wake up
automatically on the following day), or slide the switch POWER FUNCTION (1) to
OFF position. However, should music be desired, slide the switch POWER
FUNCTION (1) to position ON.
Note:
As long as the switch POWER FUNCTION (1) is set at the position AUTO or
HWS the ALARM indicator (3D) lights and you will be awakened by radio or
buzzer at the same time everyday. Set switch POWER FUNCTION (1) to OFF
position if you do not wish the radio or buzzer awaking you at the next day.
Sleep Set Operation/Automatic Disconnection
- Set POWER FUNCTION switch (1) in any position among OFF, SNZ or AUTO.
- Set the TIME SET switch (9) to SLEEP position.
- By pressing button HOUR (13) the set switches on, plays for 59 minutes
and then disconnects automatically.
You may also set a shorter playing time than 59 minutes. Then press the
button MINUTE (11) until the desired playing time between 1 and 59
minutes is indicated. The unit may be disconnected within the set playing
time by pressing the STOP button (2).
Note:
Set the TIME SET switch (9) back to LOCK position. The actual time indication
returns.