Filter
Top Products
RADIO RECEPTION
Tuning to a station
There are three possibilities for tuning in to a station:
- Automatically - the stations are sought automatically.
- Manually - This is easy if the frequency of the station is
already known (e.g. from your radio and television guide).
- Directly - The easiest way to obtain a station if its
frequency is already known.
Automatic tuning
• Keep [H] or [M] (TUNING UP or DOWN) pressed down
until thefrequency on the display changes continuously.
Tuning will stop automatically as soon as a station is
found.
•
Repeat this until you have found the desired station.
Manual tuning
• Keep [H] or [M] pressed down until you come close to
the desired frequency.
• Then briefly press the other button ([H] /[M]); tuning will
stop.
• Then press [H]] or [M] repeatedly until you reach the
desired frequency.
Direct selection
• When POWER is switched ON, press [FREQ.].
- The frequency disappears from the display.
• You can now enter the station’s frequency with the
[1...0] keys.
• Confirm the entry by pressing [FREQ.] once more.
- If you insert an invalid frequency, the display shows ‘Err ‘
• Repeat the steps above, making sure the frequency is
correct.
Preset radio stations
You can program 20 stations into the memory, 5 on each
waveband.
Programming
• Press [POWER] button to switch on the radio.
• Tune to a radio station automatically, manually or
directly.
• Press the [MEMO/TIME SET] button. The 'MEMO'
sign starts flashing on the display.
•
Press the preset button
(1...5)
to store the selected
station.
• Press [MEMO/TIME SET] button again to complete
the storing procedure.
- The program indicator "MEMO" disappears from the
display, and the preset number that was stored is
shown in the right corner of the display.
•
Repeat these steps for the other stations you wish to
program.
Calling up preset stations
• Select the wave range with [FM MW SW1 SW2]
switch.
• Press one of the [1...5] buttons.
- The frequency and the PRESET number will appear
on the display: