Filter
Top Products
RADIO RECEPTION
AM STEP selector (MW)
The minimum 'frequency distance' (span division) between
adjacent radio stations (measured in kHz) is standardized
all over the world.
However, North and South America use another standard
than the rest of the world.
This means that the radio should use a tuning step
according to the standard concerned in order to obtain
accurate radio tuning.
The AM STEP switch (in the battery compartment) allows
accurate tuning for both standards.
Position 10kHz for the Americas
- MW tuning step 10kHz;
Position 9 kHz for the rest of the
world
- MW tuning step 9 kHz;
Aerials
• For FM reception extends the telescopic aerial fully. To
improve the reception you can incline and rotate the
aerial. If the FM signal received is too strong (in the
direct vicinity of the transmitter) you can retract the
aerial.
• For the medium wave (MW), the set has a built-in aerial,
so the telescopic aerial is not needed. You can direct the
aerial by turning the set itself.
• For short wave reception (SW) extend the telescopic
aerial and position it vertically.
Radio reception
• Ensure that the LOCK-switch is off.
• Press POWER to switch the radio on.
- The frequency and the wave band will appear on the
display.
• Adjust the volume with the VOLUME control.
• You can connect headphones to the earphone socket
- The loudspeaker will then be switched off.
• Set the wave range with the FM MW SW1 SW2 switch
• If you select SW with the FM MW SW1 SW2 switch,
press METER to select the required meter band of short
wave (see the SW Tuning Table
on page 2).
- The chosen short-wave band and
the frequency will appear on the
display.
• Tune to a radio station either manually, automatically,
directly or with the PRESET buttons, see Next page.
FM MONO/STEREO
- When ' ' appears on the display, you are receiving an
FM stereo transmitter. If you are listening with headphones,
you will hear the FM station in stereo.
• A disturbing noise, due to a weak FM stereo signal, can
be suppressed by setting MONO/STEREO to MONO.
- The ' ' indication goes out and you will hear the FM
station in mono.
• Press POWER once again to switch the radio off.
- The display will now indicate the current time.