Filter
Top Products
13
8 WORKING WITH MEMORY continued
E10 OWNER’S MANUAL
E10 OWNER’S MANUAL
1. Press/release SCAN MODE (12) button.
2. Press/hold either the Up/Hour or Down/Min.
button for about a second. Then release it. Note
that PRESET ashes under the memory number,
indicating that memory scanning is functioning
with each memory being scanned for about 4
seconds. It then moves on to the next memory
for another 4 seconds.
To stop memory preset auto-scan, press/release
either the Up/Hour or Down/Min. button.
DELETING A MEMORY’S
CONTENTS
1. Press/release the SCAN MODE button (12).
2. Use the Up/Hour or Down/Min. button (5,6) to
select the memory preset location of the
frequency that you wish to delete. Alternately,
use the numeric keypad to enter the memory
number.
3. Press/hold the MEMORY button (18) for about 2
seconds and then release it. ‘dEL’ appears
ashing in the display.
4. While ‘del’ is still ashing, press/release the
MEMORY button.
DELETING ALL MEMORY PAGE CONTENTS
1. Press/release the PAGE button (11).
2. Press/hold the MEMORY button (18) for 5
seconds and then release it. ‘Del’ and PAGE
(48, 49) appear ashing in the display.
3. Within 2 seconds, press/release the MEMORY
button.
MOVING A STORED FREQUENCY
A stored frequency can be moved to a different
memory or memory page.
1. Turn on the radio.
2. Press/release the PAGE button.
3. Within 3 seconds, use the UP/HOUR or DOWN/
MIN button to select the required
memory page.
4. Press/release the MEMORY button twice.
5. Within 5 seconds use the numeric keypad to
enter the memory number that you wish to store
the station into.
6. Within 5 seconds press/release the MEMORY
button.
CUSTOMIZING MEMORY PAGES
The E10 is congured at the factory with 10
memory pages, each page having 50 memories, for
a total of 500 memories. You can change this set-up
via the SYSTEM SET CODES, shown below.
HOW TO USE THE ATS FEATURE
To automatically store your strongest local AM
and FM stations into memory, press and hold the
FM/AM-ATS button for 2 seconds. The E10 scans FM
stations rst and then AM stations, from the lowest
frequency to the highest, storing the strongest
stations into memory. Once they are stored, use the
UP/HOUR and DOWN/MIN buttons to recall the sta-
tions. During the searching/storing process, pressing
“FM/AM.ATS” stops the process, with the E10 in
memory access mode, allowing the “UP/HOUR” or
“DOWN/MIN” to access stations that were stored in
memory.
If undesired weak or noisy FM stations are stored
into memory, shorten the telescopic antenna and run
the ATS scanning process again. If undesired weak or
noisy AM stations are stored, switch the gain control
switch to NORMAL or LOCAL and run the ATS scan-
ning process again.
Stations are stored on page 0, starting with location
01, until 50 frequencies have been stored. If the
number of stations is less than 50, ATS search auto-
matically stops and the last station stored is heard.
Whenever a new ATS search is performed, the new
searched/stored stations will replace any previously
stored stations in the ATS memory.