Filter
Top Products
12
8 WORKING WITH MEMORY
E10 OWNER’S MANUAL
At the factory, the E10 is set up with 10 pages of
memory, each page holding 50 frequencies. This
enables storing of 500 frequencies into memory.
This factory setting can be changed and tailored
to your personal needs or can be left as-is. When
rst learning to store stations into memory, we
suggest using the factory setting. To change the
factory setting, see the section CUSTOMIZING
MEMORY PAGES. When working with memory,
the term PRESET appears in the display under the
memory numbers.
STORING STATIONS INTO
MEMORY
1. Turn on the radio.
2. Tune to the desired station.
3. Press/release the MEMORY button (18). Note
that the memory number digits, labeled
PRESET (48) ash in the upper right corner of
the display. The memory page number, labeled
PAGE, also appears, but does not ash.
4. Within 5 seconds use the numeric keypad to
enter the memory number that you wish to
store the station into. For memories 1-9, enter
the numbers as 01 – 09.
5. Within 5 seconds press the MEMORY button, or
wait 5 seconds. This nalizes storing into
memory and after a few seconds, the upper
right corner’s display returns to showing the
clock.
SELECTING/CHANGING
MEMORY PAGES
To select/change memory pages:
1. Press/release the PAGE button (11). The page
number ashes in the display.
2. Within three seconds, use either the UP/HOUR-
DOWN/MIN button to change to the page
of your choice. Alternately, use the numeric
keypad to enter the page.
3. Press/release the PAGE button to nalize the page
change.
ACCESSING WHAT IS STORED INTO MEMORY
There are three ways to access what has been stored
into memory: Direct Memory Access, Manual Memory
Search and Memory Auto-scan. These three methods
are described below. When the memory page and
memory preset numbers appear in the upper right cor-
ner of the display, as it will in the descriptions below,
the radio is in MEMORY ACCESS MODE. This mode can
be exited any time with a press/release of the SCAN
MODE button (12).
If you rst need to change memory pages, see the
previous section, SELECTING/CHANGING MEMORY
PAGES.
DIRECT MEMORY ACCESS
Use the numeric keypad to key-in the memory number.
For example, if the desired radio station is in memory
number 01, just press ‘0’, then ‘1’, and it will go to
memory 01.
MANUAL MEMORY SEARCH
Manual Memory Search enables manual searching
through the memories within a memory page, as
shown below:
1. Press/release the SCAN MODE (12) button.
2. Use quick, short presses on the Up/Hour-Down/
Min. buttons or use the tuning knob to search
through the memories.
3. Press the SCAN MODE button when nished.
MEMORY AUTO-SCAN
Memory Auto-scan enables scanning through the
memories within the selected memory page. Each
lled memory is accessed for about 5 seconds, after
which the scan move on to the next used memory
automatically, staying on it for about 5 seconds. This
continues indenitely on the selected page until delib-
erately stopped. Unused memories are not accessed.