Filter
Top Products
ver 1.0
4
44
4
~ÄëçäìíÉ=ÑáÇÉäáíó™
Set-up Guide
Positioning
A good starti ng position for the Genesis 5 is about 20% of the way
into the room as measured from the front wall (the wall you look at
as you are seated listening to the speakers). If you are in a smaller
room, try to have at least 24 inches (60 cm) of space from the back
of the speaker to the front wall. You may have to sit closer to the
back wall, or sit closer to the speakers, but try to keep at least 24
inches of space behind the speakers.
Start with the speakers six feet apart, and not toed-in. You will want
to sit at least 10 feet (3 metres) away from the speakers for proper
integration of the drivers. We will experiment with moving the
speakers around, and toeing them in later.
Power Connections
There are two connections you will need
to make to the G5. First, the power cord
for the built-in amplifier will need to be
plugged into a power socket. A 10-foot
power cord is included with your speakers
for this purpose. We do not recommend
using an extension cord for the G5 due to
the high power demands of the 500W
amplifier. However, if you MUST use an
extension cord, use an extremely heavy
duty one. The amplifier can draw up to 10
amps at 115v, hence make sure that the
extension cord is adequately rated.
Before you plug the power cord in, please
make sure that the voltage selector is set
to the proper voltage. Japan and North
America will require the 115v setting.
Most European countries and other Asian
countries will require 230v. The fuse is a
5amp 250v slow blow irregardless of
voltage used.
There is an on/off switch for the power
amplifier. This switch should always be
left on. We recommend that you plug the