Filter
Top Products
6
1 - HOW TO SET THE BATTERY
The P-Amp40 amplifier needs with a 9V PP3 battery (not pro-
vided).
To insert the battery into the amplifier:
- Open the battery compartment located on the base by pressing
the small plastic lock.
- Insert the 9V battery with the correct polarity into the connector in
the battery compartment.
- Replace the battery cover.
- The amplifier is now ready to be connected to the phone.
2 - HOW TO CONNECT THE P-Amp40 TO THE PHONE
To connect your phone to the P-Amp40 amplifier:
- Unplug the handset from your telephone base socket.
- Connect the small lead supplied with the P-Amp40 to the tele-
phone base socket and to the input socket (1) located at the top
of your P-Amp40 .
- Connect your handset curly cord to the output socket (2) located
at the front of your P-Amp40.
- After a few seconds the battery LED will light.
IMPORTANT: If you don’t have dial tone, you will have to use the
twelve position switch located on the bottom.This switch is used to
match the P-Amp40 to the connections in your handset because not
all telephone handset sockets have the same wiring. If you cannot
hear the dial tone or the microphone does not work properly, follow
the instructions below:
1. Replace the handset on the cradle and off hook again.
2.Turn the rotary switch position until get the dial tone in the earpiece.
INSTALLATION