Filter
Top Products
12
Nightlight Button
Power Button
and L.E.D.
Channel Switch
• Place the transmitter in the same room with child. Point the microphone towards the crib or play area.
• Set the transmitter channel switch to the same channel as the receiver(s).
• Unwrap and fully extend the AC adaptor for best transmission. Insert the AC adaptor pin into the DC
input jack on the transmitter and plug into a standard wall outlet. Use the AC adaptor only in a wall
outlet. Do not plug into a ceiling outlet.
Note: To use battery power, refer to the Battery Installation section.
• Press the transmitter power button to turn the power ON. The power L.E.D. will light.
• Press the nightlight button for a soft, glowing light. Press again to turn the nightlight off.
• Slide the nightlight timer switch to turn the timer
on. When the timer is on the nightlight will
automatically shut off after 30 minutes. To turn the nightlight back on for another 30 minutes,
simply press the nightlight button again.
Nightlight Button
Power Button
and L.E.D.
Channel Switch
Setup and Use
Nightlight Timer Switch
Nightlight Timer Switch