Filter
Top Products
Contents Copyright 2006 Final Sound Solutions.
6. ADJUSTING THE S100
Set the S100 in the desired location.
Connect the S100 to the stereo system (chapter 5).
Set the volume control to a minimum, the crossover frequency to 40 Hz, and the phase to 0 degrees.
Turn on the stereo with music you are familiar with.
Turn up the subwoofer volume to a level that matches the main speakers.
Adjust the phase control to a maximum bass output.
Readjust the volume control.
Turn up the crossover frequency until the location of the bass becomes obvious, or the bass from the subwoofer
overwhelms that from the main speakers.
Readjust the volume control.
If you have a dedicated stereo/surround setup guide/disc, refer to the directions included in it.
Note that you may need to try more than one location to reach optimum results.
7. OPERATIONAL GUIDELINES
As with all Final products, the S100 is designed to provide the highest level of performance. However, the S100 still
has limits that should be observed.
If the S100 begins to overload or heavily distort, turn down the bass or volume.
If the S100 overwhelms the output of the main speakers, turn down the volume.
If the main speakers sound strained, raise the S100 crossover frequency.
If the bass sounds loose or dislocated, adjust the phase or placement of the subwoofer until the problem disappears.
Placement of the subwoofer within the room is critical to the operation of the S100. Recommended locations
include the center of the front wall, either front corner, or the center of the side walls.
If the S100 malfunctions, turn the subwoofer off and on. If the problem persists, contact your dealer for additional
troubleshooting.
7