Filter
Top Products
20. Attach secondary support lines — If required, attach all of the secondary support
lines as shown in figure 21.
ATTENTION: Do not allow any slack in the support cables.
NOTE: If the CS 26T will be installed in the CS 120P, do not attach secondary
support cables to the speakers.
Secondary Support
Cables (3)
Attach cables here
and secure.
Anchor ends to suitable
solid secure points within the
permanent building structure.
SC 26T with PRE 120
Open Back
Secondary Support
Cable
Figure 21. Attaching Secondary Support Lines
NOTES:
• When placing the CS 120P on a tile grid with a grid face less than 15/16 inch
(24 mm) and no ceiling tile is installed, use the secondary attachment points
as hanger suspension points.
• Observe all applicable building codes and local ordinances when installing the
speaker.
21. Replace the adjacent tile — Reinstall the adjacent tile that was removed in step 4.
CS 26T and CS 120P User Guide • Installation 13