Filter
Top Products
PAGE 20
FireBall™ SE-160i User’s Manual
RS-232 CONNECTIONS
COM port is to be used for connecting an Escient ETP-1500 wired touch panel or to interface with a third party control system such as Opus, AMX
or Crestron.
Note: You should use the Ethernet control system for controlling FireBall from a third party control system whenever possible. Using the Ethernet control
system frees up the COM port for other purposes, allows much longer distances between FireBall and the control system, and provides a much faster path
for data transfer.
IR CONNECTIONS
The direct IR input jack on the back panel of the FireBall is for controlling FireBall from a wired IR distribution system such as a Xantech system.
This connection must be an IR signal with a 36kHz carrier using an 1/8” mono or stereo connector.
The IR input jack provides 12V power. This means that you can directly connect a 12V IR receiver (like the Xantech series 291 units) to the FireBall
using a 1/8” stereo connector.
Pin outs for the Wired IR input
• Sleeve = +12v
• Ring = Ground
• Tip = Signal