Filter
Top Products
25
4.) Press the OPEN/CLOSE button to close the CD door.
The flashing dashes “– – – – – – ” appear in the display as the player reads the
Table Of Contents on each disc.
After reading the last disc the display will
show the total tracks and playing time of
DISC 1.
NOTE: It may take 15 to 20 seconds for the player to read the TOC of all 3
discs. The reading time may be even longer if you are using CD-RW
(ReWritable) discs. This is normal and not an indication of any problem
with your unit.
5.) Press the
PLAY/PAUSE button to
begin playback ALL DISC.
To playback only Disc 1, Disc 2 or Disc 3,
press the CD1, CD2 or CD3 buttons.
6.) When playback begins, adjust the VOLUME and EQ controls as desired.
7.) To skip to higher or lower numbered tracks press the
or until the desired
track number appears in the display, then release the buttons. Playback will
begin on the desired track.
8.) To pause temporarily during CD playback press the
PLAY/PAUSE button
again.
The sound stops and the elapsed time
flashes in the display, but the disc
continues spinning.
Press the
PLAY/PAUSE button once more to cancel Pause mode and
resume playback at the same point.
MS3108_062806.p65 28/6/2006, 16:5425