Filter
Top Products
20
Listening To The Radio
1.) Press the
STANDBY (POWER) button to turn the system ‘On’. The display
lighting comes ‘On’ and the STANDBY light goes ‘Off’.
2.) Press the FUNCTION button on front panel or TUNER button on remote control
to select the Tuner function.
An AM or FM frequency will appear on
the display.
Press the
STOP/BAND button again
to switch between the AM and FM bands
if necessary.
3.) Tune to the desired station as follows:
• Manual Tuning
Repeatedly press
the or buttons until the display shows the exact
frequency of the desired station. Use the Manual Tuning method to tune to
weak or distant stations that are not strong enough to be recognized by the
Automatic Tuning system.
• Automatic Tuning
Depress and hold
the or buttons until the display begins to move, then
release the buttons. The Tuner will search up or down the band for the next
strong signal and stop on that station. Repeat this procedure until the tuner
stops on your desired station.
4.) If you tuned to an FM Stereo station the
STEREO indicator will appear in the
display.
5.) Adjust the VOLUME, and EQ controls to the desired settings.
6.) When you are finished listening press the
STANDBY (POWER) button to
return the system to the Standby (Off) mode. The display lighting goes ‘Off’
and the STANDBY light comes ‘On’.
MS3108_062806.p65 28/6/2006, 16:5420