Emerson HD7097 CD Player User Manual


 
7
OPERATING INSTRUCTIONS
NORMAL PLAYBACK
1.) Connect the headphones to the PHONES jack.
Set the VOLUME control to a low level before
you begin playback and then adjust the volume
to a comfortable level after playback begins.
2.) Slide the CD Door OPEN switch to the right to
release the lock and open the CD Door.
3.) Place your disc on the center spindle with the
printed label side facing up. Press down gently
near the center hole to make sure the disc is
properly seated on the spindle.
4.) Close the door completely until it locks shut.
5.) Press the PLAY/PAUSE button to begin
playback on Track 1. Joggable indicator flashes
and the playing time shows in the display.
6.) Adjust the VOLUME and DBBS (Bass Boost)
controls as desired.
7.) When all tracks have been played the player stops
and the display shows the total tracks and playing
time on the disc. After approximately 1 minute the
power shuts off and the display goes blank.
To stop playback before the disc ends press the
STOP button at any time. Press the STOP
button again to shut the power off immediately.
8.) Slide the CD Door OPEN switch to the right to
open the door and remove your disc. Close the
CD Door and return your disc to its protective
storage case.
ON
DBBS
OFF
PLAY/PAUSE
VOLUME
OPEN
STOP
To PHONES Jack
J-ASP
HD7097_ib060702.p65 7/6/2002, 15:057