Filter
Top Products
10
CLOCK SETTING
1.) Switch the unit to Standby mode by pressing the POWER button.
2.) Press the PROG / MEMORY button. The
hour digits will flash in the display.
3.) Use the / buttons to set the required hour. Be sure to set correctly for
AM or PM.
4.) Press the PROG / MEMORY button again.
The Hour is now set and the Minute digits
start to flash in the display.
5.) Use the / buttons to set the required minute.
6.) Press the PROG / MEMORY button again.
The Minutes are now set and the clock
will start.
NOTE:
• Clock time is only retained while the unit is plugged into the AC outlet. In the
event of a power failure the clock will need to be reset when the power supply
resumes.
• Clock time is only shown when unit is in Standby mode.
AM
PM
PM
ES27_ib_drafts.p65 19/3/2002, 16:0910