Filter
Top Products
11
Radio operation
FM/AM radio operation
Note:
Note:
1. Enter the Tuner function by pressing the FM/AM-button on the remote or on the front panel. The tuner will start
in the last known state. Press the FM/AM-button again to change between the FM and AM band.
2. Search stations:
A) To directly input the frequency, press the FREQUENCY-button on the remote, and then enter the prefered
frequency via the 0-9 digits on the remote.
B) To autosearch all frequencies press the SEARCH-button on the remote. The unit will now search the FM
band in 0,05MHz steps, and the AM band in 9KHz steps. During autosearch all stations that has been found
automatically will be stored. Press the SEARCH-button once again to stop the autosearch.
C) To search station on at the time press the TUNE+/>>- or the TUNE-/<<-button on the remote. The unit will
then search the selected band until it finds a station. The unit will search the FM band in 0,05MHz steps, and
the AM band in 9KHz steps.
3. Saving presets
Once a frequency has been found, by either autosearch or manual search, press the SAVE-button on the
remote, and the frequency will be saved on the chosen preset. A little padlock will be shown in the display when
the frequncy has been saved to a preset. If you want to save the frequency 92,9MHz to preset 23, choose
preset 23 by pressing the +10-button on the remote twice and then the 3-button on the remote. Press the
FREQUENCY-button on the remote and press929omtheremote. Press the SAVE-button to store the preset.
4. Choosing a preset.
Once the prefered radio stations has been stored as presets, they can be chosen by either pressing the
CH+/>>I or the CH-/I<< buttons, to step on preset up or down at the time, or the prefered station can be
selected directly by using the 0-9 digits and the +10 button. If you want to listen to preset number 26, press the
+10-button on the remote twice, and then press the 6-button on the remote.
5. Stereo and mono sound selection
To change between MONO and STEREO during FM playback, press the MONO-button on the remote. The unit
will always start up in stereo if possible. When stereo is chosen, a little borken circle will be shown in the
display. If the signal is not strong enough, stereo cannot be chosen.
Stereo is not available in AM.
To obtain the best possible reception, move the included FM or AM antenna untill the strongest signal is found.