Elta 2444MP3 CD Player User Manual


 
TROUBLESHOOTING GUIDE
Should this unit exhibit a problem, check the following before seeking service.
RESET
If this product does not operate properly, insert the tip of an unbent paperclip (or
similar) into the opening to reset the display and memory as the figure shown
below.
In case of malfunction due to electrostatic discharge, please reset the product
(reconnection of power source may be required) to resume normal operation.
027.
Symptom
Radio
Noise or sound distorted on AM
or FM broadcasts.
FM STEREO does not appear
on display.
AM or FM, no sound.
Compact Disc Player
CD Player will not play.
CD skips while playing.
Function inoperative
and jammed
Display no indication or
abnormal indication
Possible Cause
Station not tuned properly for
AM or FM
FM: Wire antenna is not
extended.
AM: The bar antenna is not
positioned correctly.
You have tuned to a mono
station or station too weak.
Unit not at Tuner function AM or
FM band.
Volume at minimum.
Unit not in CD function mode.
CD is not installed or installed
incorrectly.
Disc is dirty or scratched.
Built-in microcomputer hand
up.
Built-in microcomputer hand
up.
Solution
Retune the AM or FM
broadcast station.
Extend FM Wire antenna.
Reposition the unit until best
reception is obtained.
Select another FM station.
Press Tuner / Band button to
AM or FM.
Increase Volume.
Press CD Function button.
Insert CD with label side up.
Wipe disc with cloth or use
another disc.
Use a sharp tip to press into the
reset hole to reset the built-in
microcomputer.
Use a sharp tip to press into the
reset hole to reset the built-in
microcomputer.
2444MP3 DE,GB,FR &HR 9/7/05 3:29 PM Page 027