Filter
Top Products
Electro-Voice EVF/EVH User Manual 33
A basic three-over-three cluster is shown in Figure 23.
MAIN SUSPENSION LINES AND PULL BACKS MUST BE TIED TO THE TIE PLATES.
NOTE THAT THE HRK KITS ARE DESIGNED TO MAKE WEIGHTSYMMETRICAL CLUS
TERS, I.E., THOSE WHOSE LEFTTORIGHT CENTER OF GRAVITY IS IN THE CENTER OF
THE CLUSTER.
The following components are needed to achieve this cluster:
1. Four HRK-2 horizontal rigging kits for EVF to EVF subwoofer/EVH.
2. User-supplied hardware to link the upper cluster to the lower cluster.
5.0 EVF and EVH Rigging System (cont’)
EVF Full-Range
Systems (x4)
HRK-1 Kit (x2)
(Sold Separately)
Tie Plates
(As Shipped,
Attached to the
Rigging Plates
Within the
HRK Kits)
Rigging Plates
(Within the
HRK Kits)
Figure 22a:
A four-enclosure horizontal hang
of two EVF full-range systems
above and two EVF full-range
systems below, connected by two
HRK-1 kits (optional accessories)
and user-supplied hardware to
link both clusters, using a
moderate trim angle
Figure 22b:
A four-enclosure horizontal hang
of two EVF full-range systems
above and two EVF full-range
systems below, connected by two
HRK-1 kits (optional accessories)
and user-supplied hardware to
link both clusters, using a
more extreme trim angle
Figure 22c:
A four-enclosure horizontal hang
of two EVF full-range systems
above and two EVF full-range
systems below, connected by two
HRK-1 kits (optional accessories)
and user-supplied hardware to
link both clusters, using an
extreme trim angle
Optional Stabilization
Points
Tie Plates