Filter
Top Products
17.06"
433.3mm
19.00"
482.6mm
3.49"
88.8mm
1.85"
46.9mm
INDICATES CENTER OF GRAVITY
1.54"
39.1mm
15.43"
392mm
PA-600 AMPLIFIER INSTALLATION & MOUNTING
The PA-600 is specifically designed to be rack mounted, either as a permanent
fixture or in a "mobile" rack. As with any large, heavy object, a proper
installation could mean the difference between success and disaster. The front of
the unit is designed to attach to standard rack rails. The four outermost holes
correspond to the screw on standard rack rails (2 rack spaces in height). Use only
10-32 threaded rack screws with large heads (such as a truss heads). The use of
nylon rack mount washers between the screw heads and the faceplate will keep
the faceplate from being scratched. Due to the depth and weight of the PA-600 a
set of rear support holes have been provided. It is highly recommended that the
installer use these holes to support the rear of the amplifier. A support rail, shelf,
or bracket can be attached to the amplifier and then to the installation
enclosure. One thought to keep in mind when considering the related hardware
for this: more is better when it comes to a secure installation - a little extra time
spent on installing a heavy object more than offsets the possible losses that
could be incurred if the object were to be damaged due to inadequate support.
The dimensions below are provided to assist you and/or your installation
engineer in mounting the amplifier securely.
-8-
Specifications & features are subject to change without notice. www.earthquakesound.com