Dynacord Speaker Speaker User Manual


 
SUB 112
31
Sub 112
SUBWOOFER
The DYNACORD Sub 112 is a
vented, direct-radiating cabinet
equipped with a high-power
DYNACORD DND12S400 neodymium
woofer boasting power handling
of 400 W (rated) and 1600 W
(peak).
The conical vent system results in
less flow loss and lower air noise
than conventional vented designs.
High sound pressure levels are
also generated at low frequencies
with significantly less distortion
than by conventional bass reflex
vents. The Sub 112 contains a
passive low-pass filter with a slope
of 6 dB / octave. The Sub 112
can therefore be used directly in
parallel to appropriate full-range
cabinets, e.g. the DYNACORD D 8,
if extended bass reproduction is
required.
The Sub 112 cabinet is composed
of birch plywood 15 mm-thick.
All corner joints and braces are
grooved and glued. The cabinet‘s
surface is painted with a robust,
dual component lacquer finish.
The acoustic foam and powder
coated steel grille at the front
protect the DND12S400 woofer
from harm during transportation
and against the depredations of
inclement weather. The connection
panel offers two 4-pin Speakon
sockets (INPUT / THRU) for a more
secure connection and the easy daisy-
chaining of cabinets. A threaded
pole adapter is recessed in the top
of the Sub 112 cabinet for the swift
and safe pole-mounting of suitable
full-range cabinets. The cabinet is
equipped with four large rubber feet
for greater stability. Two handles on
the side make it possible to carry
the device easily and safely.
A hard-wearing protective cover is
available as an optional accessory.
dc loudspeaker_en_reprint062010.indd 31dc loudspeaker_en_reprint062010.indd 31 09.07.10 12:1609.07.10 12:16