Filter
Top Products
DIGITAL SYSTEM AMPLIFIER
30 Owner‘s Manual / Bedienungsanleitung
Specifications/Technische Daten
Amplifier at rated conditions, both channels driven, 8 Ω load, unless otherwise specified.
Depending on the ambient temperature, the unit might not operate continously at 2 Ω load in Dual Mode or 4Ω in Bridged Mode.
In addition input power exceeds 1.1 times rated power consumption with 2 Ω load in Dual Mode or 4 Ω load in Bridged Mode
DSA 8204 DSA 8206 DSA 8209 DSA 8212
Load Impedance 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω
Maximum Midband Output Power
THD = 1%, 1 kHz, Dual Channel
650 W 450 W 270 W 900 W 600 W 380 W 1250 W 900 W 550 W 1800 W 1200 W 750 W
Rated Output Power
THD < 0.1%, 20 Hz...20 kHz
- 400 W 200 W - 500 W 250 W - 800 W 400 W - 1100 W 550 W
Maximum Single Channel Output Power
Dynamic-Headroom, IHF-A
1150 W 660 W 350 W 1700 W 950 W 480 W 2450 W 1400 W 700 W 3400 W 1800 W 950 W
Maximum Single Channel Output Power
Continuous, 1 kHz
850 W 540 W 310 W 1200 W 750 W 420 W 1700 W 1100 W 630 W 2400 W 1500 W 850 W
Maximum Bridged Output Power
THD = 1%, 1 kHz
- 1300 W 900 W - 1800 W 1200 W - 2800 W 1800 W - 3600 W 2400 W
Maximum RMS Voltage Swing
THD = 1%, 1 kHz
55.3 V 65.1 V 78.8 V 90.6 V
Power Bandwidth
THD = 1%, ref. 1 kHz, half power @ 4 Ω
< 10 Hz...30 kHz
Voltage Gain, ref. 1 kHz 32.0 dB
Input Sensitivity
rated power @ 8 Ω, 1 kHz
+2.2 dBu (1.0 V
rms
) +3.1 dBu (1.11 V
rms
) +5.1 dBu (1.39 V
rms
) +6.6 dBu (1.66 V
rms
)
THD at rated output power
MBW = 80 kHz, 1 kHz
< 0.03%
IMD-SMPTE, 60 Hz, 7 kHz < 0.1%
DIM30, 3.15 kHz, 15 kHz < 0.05%
Maximum Input Level +21 dBu (8.69 V
rms
)
Crosstalk
ref. 1 kHz, at rated output power
< -80 dB
Frequency Response, ref. 1 kHz 10 Hz...40 kHz (±1 dB)
Input Impedance, active balanced 20 kΩ
Damping Factor, 1 kHz > 300
Slew Rate 25 V/μs 26 V/μs 27 V/μs 30 V/μs
Signal to Noise Ratio Amplifier
A-weighted
> 106 dB > 107 dB > 109 dB > 110 dB
Output Noise, A-weighted < -71 dBu
Output Stage Topology Class AB Class H
Power Requirements 240 V, 230 V, 120 V or 100 V; 50 Hz...60 Hz (factory configured)
Power Consumption
1/8 maximum output power @ 4 Ω
550 W 700 W 700 W 850 W
Mains Fuse 240 V / 230 V: T10AH;
120 V / 100 V: T20AH
240 V / 230 V: T12AH;
120 V / 100 V: T25AH
240 V / 230 V: T15AH;
120 V / 100 V: T25AH
240 V / 230 V: T15AH;
120 V / 100 V: T30AH
Protection Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn-
on delay
Cooling Front-to-rear, 3-stage-fans
Ambient Temperatur Limits +5 °C...+40 °C (40 °F...105 °F)
Safety Class I
Dimensions (W x H x D), mm 483 x 88.1 x 421.5
Weight 12.6 kg (27.8 lbs) 14.8 kg (32.6 lbs) 16.3 kg (35.9 lbs) 17.7 kg (39.0 lbs)
Signal Processing Lo-Cut 50 Hz / 18 dB, switchable
Options 2-Way crossover, internal filter card, 24 dB, LR, 500 Hz (NRS 90250), 800 Hz (NRS 90251)
Rear-rackmount D113223 (RMK-15)