Dual SBP10 Speaker User Manual


 
4
SBP10 INSTALLATION
Enclosure Guidelines
To achieve the best possible sound from this subwoofer enclosure, Dual
recommends aquiring the services of a professional car audio installation center.
If you feel confident in your ability to install this product without the assistance of
a professional, please read this section thoroughly. We have provided a number
of placement recommendations and installation tips to assist you. Keep in mind
that these are provided as a guideline and you may nd that other placements
may provide better results for your specic vehicle.
• Make sure all moving parts and factory electrical wires are out of the way and
will not interfere after installation.
• Ensure the wire is of sufcient length to avoid pulling or stretching. This is even
more important if the wires will be run under or through the factory interior.
• Use electrical tape and wire ties to ensure all wires are properly secured.
• Avoid installing speakers or electronics where they can be subject to moisture.
• Ensure the speaker wires are connected using correct polarity. The positive
polarity is marked by a (+) sign. Incorrectly connected subwoofers will result in
limited bass output.
• Ensure the Illuminite wires (12V) are connected using correct polarity. Do not
connect an amplifier or any audio output source to the Illuminite inputs, as
doing so will cause permanent damage to the lighting elements.
• Speaker wire should be isolated from the vehicle’s electrical system to avoid
noise being picked up by the amplifiers.
• We recommend using 14 gauge or larger sized speaker wire to ensure your
subwoofer receives the full power output of your amplier.
• Remember to listen responsibly and respect your ears. Being exposed to
sounds over 125dB for even short periods of time can create permanent
hearing loss!