Filter
Top Products
2
SBP10 PREPARATION
Getting Started
Thank you for purchasing the Dual Electronics SBP10 Bandpass Subwoofer
System. Although Dual has attempted to ensure the information in this manual is
accurate, please be aware that any part of it is subject to change without notice.
Safety
CAUTION
!
THE FOLLOWING INSTRUCTIONS ARE DESIGNED TO ENSURE SAFETY
DURING INSTALLATION AND USE OF THE SBP10. FAILURE TO HEED THESE
INSTRUCTIONS CAN RESULT IN INJURY OR DAMAGE TO THE UNIT.
• To prevent injury and damage to the unit, please read and follow the
instructions in this manual.
• If you feel unsure about installing this system yourself, have it installed by a
qualified audio technician.
• Before installation, disconnect the battery negative (-) terminal to prevent
damage to the unit, fire and/or possible injury.
• Do not connect amplier or any audio source to illumination inputs. These
inputs are designed for 12 volt power only.
• Illuminite inputs are designed for 12 volt DC power source only. Do NOT
connect your illuminite product directly to your battery permanently, as it will
cause your battery to discharge. Please use a switched 12 volt source.