Directed Electronics XA-3002 Stereo Amplifier User Manual


 
4
© 2006 Directed Electronics—all rights reserved
INSTALLATION GUIDELINES
High-powered car audio
systems may produce sound
pressure levels that exceed the
threshold at which hearing loss may
result.
They may also impair a driver’s ability to
hear traffic sounds or emergency vehi-
cles. Use common sense and practice
safe listening habits when listening to or
adjusting your audio system.
WARNING
FEATURES
High-speed MOSFET power supplies
Complimentary bipolar transistor
outputs
Either mono only (XA-8001, XA-
5001) or stereo/mono (XA6002).
The XA-6004 can have rear bridged
and front stereo or variations
thereof.
2 ohm stereo stable/4 ohm mono
stable
Built-in 2-way variable crossovers
+6 or +12 dB switchable bass
boost (+8dB on XA-6004)
Adjustable input gain
Power/status LEDs
Thermal, short-circuit, over-current,
and reverse polarity protection
Chrome-plated RCA inputs
Heavy duty screw terminals
1. Please read this owner’s manual
carefully before installing this ampli-
fier.
2. Disconnect the battery ground
terminal prior to making any elec-
trical connections.
3. Check for any hazards or obstruc-
tions such as gas tanks, fuel or
brake lines, and wiring harnesses
before mounting the amplifier.
4. Pick a mounting location that will
provide adequate access and venti-
lation and protect the amplifier
from heat, moisture, and dirt.
5. Avoid sharp metal areas when
routing cables to the amplifier, and
run RCA cables away from the
power cables and other potentially
noisy car harnesses.