Directed Electronics TD275/2150 Speaker System User Manual


 
Noises While the Engine is On
Alternator whine:
This noise changes in frequency with engine RPM. Check for:
.
Excessive input level setting on the amplifier
.
High resistance in cabling or corroded and/or loose connections
.
Polarity of the input cables
If the problem persists, check the
whines and pops checklist
below.
Ticks/buzz:
This noise should go faster and slower with engine RPM, but not really change in
frequency. This is due to the ignition or the fuel pump.
.
Try moving the input cables to avoid contact with the fuel pump or wiring
If the problem persists, check the
whines and pops checklist
below.
Accessory pop:
This popping noise occurs as the result of turn signals, brake lights, etc. You can
try:
.
Moving the cables to avoid contact with the wires for the accessories
.
Relocating various ground connections
Whines and pops:
If you have a combination of noises, or if one or more of the problems listed above
persists despite efforts to stop the problem, the noise may be caused by one or
more of the following problems:
.
Excessively high input level setting on the amplifier
.
Poor or open shielding, extra long cables or corroded input cables
.
Bad connections
.
Bad (or high resistance) system ground
.
Reversed polarity on audio signal cables
.
Poor quality source unit
13
BACK TO CONTENTS