Filter
Top Products
Getting Started Connections Setup Playback Setting the Timer Other Functions
ENGLISH
Specifications
Symptom Cause Countermeasure Page
Buzzing noise in
FM broadcasts.
• The antenna cable is not properly
connected.
• Noise interference from a nearby
electronic device equipped with
a microprocessor, or the radio
broadcast signal is weak.
• Connect the antenna properly.
• Reposition the equipment or the
positions or directions of the
connection cables, antenna, etc.
• Connect an outdoor antenna.
12
–
–
Hissing or buzzing
noise is heard in
AM broadcasts.
• Noise interference from a
nearby monitor, etc., or there
is interference in the broadcast
signal.
• Turn off the monitor.
• Change the position or direction
of the AM loop antenna.
• Connect an outdoor antenna.
–
–
–
Humming noise
is heard in AM
broadcasts.
• There is interference from current
in power cords.
• Connect an outdoor antenna. –
GTunerH
Symptom Cause Countermeasure Page
When playing
records, a wailing
noise (howling) is
produced when
the volume is
raised.
• The player and speakers are too
close together.
• The floor is soft and vibrates
easily.
• Move the player and speakers as
far apart as possible.
• Use cushions or spikes to absorb
the vibrations of the speakers
being conveyed from the floor.
–
–
GRecord PlayerH
Symptom Cause Countermeasure Page
Disc tray does not
open.
• The power is not on. • Turn on the power. 14
“NO DISC” is
displayed even
though a disc is
loaded.
• The disc is not properly loaded. • Reload the disc. 3
“00 : 00” is
displayed even
though a disc is
loaded.
• A disc other than a CD or Super
Audio CD is loaded.
• Load a CD or Super Audio CD. 3
Playback does not
start even when
the 1/3 button is
pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or
replace the disc.
3, 4
No digital signals
are output.
• For Super Audio CDs, no digital
signals are output.
• Turn the pure direct mode on.
• For Super Audio CDs, use the
analog audio output signals.
• Turn the pure direct mode off.
11
15
A specific section
of the disc
cannot be played
properly.
• The disc is dirty or scratched. • Wipe the dirt off the disc or
replace the disc.
3, 4
Programmed
playback is not
possible.
• The tracks have not been
programmed properly.
• Program properly. 17
A CD-R or CD-RW
disc cannot be
played.
• The disc has not been finalized.
• The recording conditions are bad
or the quality of the disc itself is
poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
3
–
Files recorded
in MP3 or WMA
format cannot be
played.
• You have selected a copyright-
protected WMA file or a file that
cannot be played normally.
• Press the
8 or 9 button to
select a different file.
19
GCDH
Symptom Cause Countermeasure Page
iPod cannot be
played.
• Device you want to play and set
input source do not match.
• Cable is not properly connected.
• Control dock for iPod’s AC
adapter is not connected to
power outlet.
• Select an appropriate input
source.
• Reconnect.
• Plug the control dock for iPod’s
AC adapter into a power outlet.
22
10
–
GiPodH
Troubleshooting
1.RCD-CX1_ENG.indd 29 2008/05/30 11:20:45