Filter
Top Products
10
ENGLISH
q
Track, minute, second and frame
displays
• These displays indicate current position
information.
w
Time mode indicators
• When the TIME button is pushed, the Time
mode indicator switches as follows:
ELAPSED:
Track’s elapsed time is displayed.
REMAIN:
Track’s remaining time is displayed.
T. ELAPSED:
The total elapsed time of disc is displayed.
T. REMAIN:
The total remaining time of disc is displayed.
e
Play mode indicators
• When SINGLE indicator lights up, playback will
finish at end of current track.
• When CONT. indicator lights up, playback
continues.
r
BPM indicators
• Lights when the BPM is displayed on the pitch
display.
t
MP3 indicators
• Lights when an MP3 disc is detected.
y
Loop mode indicators
• DN-S1000 has Loop mode indicators which
consist of A , B and two arrows. A and B
marks indicate A and B points have been set.
• Two arrows indicate loop setting mode as
follows.
or Left arrow only on:
Hot Start mode
Both arrows on:
Seamless Loop mode
, Both arrows flashing:
Seamless Loop Playing
,
Left arrow on, right flashing:
Exit play from Seamless Loop
u
MP3 file search mode indicator
FILE:
FILE indicator appears in display, when in
the FILE name search mode.
FOLDER:
FOLDER indicator appears in display, when
in the FILE & FOLDER name search mode.
TITLE:
TITLE indicator appears in display, when in
the TITLE name search mode.
ARTIST:
ARTIST indicator appears in display, when in
the ARTIST name search mode.
BPM
BPM
TITLE
q
tuyio!
0
y!
1
!
2
w e r
(4) Display
i
Character display
• You can select the mode or function using
PARAMETERS knob following the short
message which is displayed on the character
display area.
• The character display indicates the operation,
mode name, data, etc., and displays such
guide messages as “Push/Play” means if
“YES”, push PARAMETERS knob. The display
indicates and marks sometime, note
that mark says you to turn PARAMETERS
knob and marks says to push
PARAMETERS knob.
• The PARAMETERS LED flashes when you can
use PARAMETER knob, otherwise this knob
used for Track Selection.
o
Play Position indicators
• Play position indicator:
The 30 dots indicate a visual track position
marker during normal play. The 10 Orange
dots indicate the play position during the
reverse play mode.
• End of Message:
When the time remaining to the end of the
track is less than the specified time, the EOM
(End Of Message) play position indicator
flashes along with the remaining time,
notifying of the track end.
✽ The EOM time can be set in the presets.
!0
KEY ADJ. indicator
• KEY ADJ. indicator appears in display when
the Key Adjust mode is ON.
!1
MEMO indicator
• MEMO indicator appears in display when
there is a memo setting found for the current
playing track or the track at which the Cue
standby mode is currently set.
!2
Pitch display
• This indicator display the playback speed
(pitch).
4
COMPACT DISCS
1. Precautions on handling compact discs
• Do not allow fingerprints, oil or dust to get on the
surface of the disc.
If the disc is dirty, wipe it off with a soft dry cloth.
• Do not use benzene, thinner, water, record spray,
electrostatic-proof chemicals, or silicone-treated
cloths to clean discs.
• Always handle discs carefully to prevent
damaging the surface; in particular when
removing a disc from its case or returning it.
• Do not bend the disc.
• Do not apply heat.
• Do not enlarge the hole in the center of the disc.
• Do not write on the label (printed side) with a
hard-tipped implement such as a pencil or ball
point pen.
• Condensation will form if a disc is brought into a
warm area from a colder one, such as outdoors
in winter. Do not attempt to dry the disc with a
hair dryer, etc.
2. Precautions on storage
• After playing a disc, always unload it from the
player.
• Always store the disc in the jewel case to protect
from dirt or damage.
• Do not place discs in the following areas:
(1) Areas exposed to direct sunlight for a
considerable time.
(2) Areas subject to accumulation of dust or high
humidity.
(3) Areas affected by heat from indoor heaters,
etc.