Filter
Top Products
6
ENGLISH
Audio cable
Cable indications
The hookup diagrams on the subsequent pages assume the use of the following optional connection
cables (not supplied).
NOTE:
•Do not plug in the power supply cord until all connections have been completed.
•When making connections, also refer to the operating instructions of the other components.
•Be sure to connect the left and right channels properly (left with left, right with right).
•Do not bundle power cords together with speaker cables. Doing so could result in humming or noise.
Connections
Analog connections (Stereo)
A
R
L
R
L
Pin-plug cable
(White)
(Red)
Speaker connections
C
Speaker cable
Analog connections (Monaural, for subwoofer)
B
Pin-plug cable
Video connections
D
Video cable (75 Ω/ohms video pin-plug cable)
(Yellow)
Signal direction
Audio signal
OUT ININ OUT
Video signal
OUT ININ OUT
Speaker Impedance
Connecting the speaker cables
Speaker connections
Connect the speaker terminals with the speakers
making sure that like polarities are matched (
<
with
<
,
>
with
>
).
¢Speaker impedance
Note on speaker impedance
When using speakers with an impedance
below the designated value (for example 4
Ω/ohms), playing for long periods of time with
the volume high could cause the temperature
to rise, activating the protection circuit.
When the protection circuit is activated, the
output to the speakers is cut off and the power
indicator blinks. If this happens, unplug the
power cord, wait for the set to cool off and
improve ventilation around the unit. Also check
the wiring of the input cables and the speaker
cables. After doing this, plug the power cord
back in and turn the unit’s power back on.
If the protection circuit is activated again even
though there are no problems with the wiring or
the ventilation around the unit, switch off the
power and contact a DENON service center.
NOTE:
When making connections, take care that
none of the individual conductors of the
speaker cable come in contact with adjacent
terminals, with other speaker cable
conductors, or with the rear panel and
screws.
NEVER touch the speaker terminals when
the power is on. Doing so could result in
electric shocks.
1. Loosen by turning
counterclockwise.
2. Insert the cable.
Either tightly twist or terminate the
core wires.
3. Tighten by turning clockwise.
4 ~ 16 Ω/ohmsA, B
8 ~ 16 Ω/ohmsA+B
Connecting banana plugs
Turn clockwise to tighten, then
insert the banana plug.
ENGLISH