Filter
Top Products
Connections Connections
9
ENGLISH
Connecting the iPod
®
iPod
ASD-1R
A
AUDIO OUT
L
R R
L
When using an iPod, you must connect the Control Dock for iPod (ASD-1R, sold separately) and the DOCK
CONTROL jack on the DRA-37 with a mini-jack and assign the iPod to any AUDIO terminal(s).
The diagram below shows an example of connections for when the iPod is assigned to the CD-R/TAPE
terminals.
For instructions on assigning the iPod to a specific terminal, see “Setting the iPod Assignment” (
page 14).
For instructions on playing the iPod, see “Playing the iPod” ( page 14).
•The optional standard Control Dock for iPod is DENON ASD-1R sold separately.
Monitor (S VIDEO IN)
Connecting a room-to-room remote control unit
NOTE:
•For instructions on installation and operation of separately sold devices, refer to the devices’
operating instructions.
+
+
Output
Input
AUX OUT
RC-616
Infrared retransmitter
RC-617 Infrared sensor
Extension terminals for future use.
RC-617 Infrared sensor
RC-616
Infrared retransmitter
Connecting the PRE OUT terminals
R
L
A
R
L
R
L
Power amplifier
Input
Output
Connecting the power supply cord
AC 120 V, 60 Hz
AC outlet
(wall)
NOTE:
•Insert the plugs securely. Incomplete connections will result in the generation of noise.
•Only use the AC OUTLETS for audio equipment. Never use it for hair driers, monitors or other
electrical appliances.
AC OUTLETS
•SWITCHED (total capacity – 120 W (1 A))
The power to the outlet is turned on and off in
conjunction with the POWER switch on the
main unit, and when the power is switched
between on and standby from the remote
control unit.
No power is supplied from this outlet when
this unit’s power is at standby. Never connect
equipment whose total power consumption
exceeds 120 W (1 A).
ENGLISH