Filter
Top Products
• Functions can be preset using the buttons on the front panel. These presettings are stored in a permanent memory, so they are not cleared even
when the power is turned off.
• The functions shown on the table below can be preset. Set the functions according to the usage purpose to efficiently achieve even higher quality
playback.
• One of the preset functions can be used to display information on this set (microprocessor version).
Preset function type Description Character display
(as set upon shipment from
factory)
No.
Preset type Selection of preset type Preset Type 1 1
Auto cue Setting of audio startup level for auto cue function CueDet.-60db 2
Auto stop Setting of whether or not to automatically stop the servo functions Sleep ON 3
FS converter Setting of whether or not to use the FS converter and sampling frequency
setting (when optional FS converter mounted)
FS OFF 4
Program 1 Setting of whether or not to play program 1 Program1 OFF 5
Program 2 Setting of whether or not to play program 2 Program2 OFF 6
Program 3 Setting of whether or not to play program 3 Program3 OFF 7
Digital output Selection of output signal format D.Out Pro 8
Digital output Selection of whether or not to output subcodes Subcode OFF 9
End monitor Setting of whether or not to use the end monitor function and monitor
time setting
End Mon. 10sec 10
E.O.M. Setting of whether or not to display the EOM and display time setting E.O.M. 10sec 11
Next track standby Setting of whether or not to standby at the next track when the
STANDBY/CUE button is pressed during playback
NextStb.OFF 12
Fade in time Fade in time setting Fadeln OFF 13
Fade out time Fade out time setting Fadeout OFF 14
Play speed Standard playing speed setting Normal Speed 15
Delay start Delay start time setting Delay OFF 16
Play lock Selection of whether or not to inhibit the panel switches during playback PlayLock OFF 17
Frame display Selection of whether or not to display frames FR Disp ON 18
CDR disc Selection of whether or not to play CDR discs which do not include a TOC CD-R NO TOC 19
CDR disc Selection of whether or not to play skip tracks on CDR discs CD-R Skip OFF 20
Serial remote Baud rate setting 9600bps 21
Switch protect Selection of whether or not to enable the panel switches Switch ENA 22
Player ID Selection of whether or not to set player IDs and selection of ID number PlayerlD OFF 23
Parallel remote Selection of whether or not to accept parallel remote signals Remote ENA 24
Parallel remote Selection of whether or not to output standby tally ST. Tally ON 25
Parallel remote External control tally output signal setting Index2 Tally 26
Parallel remote Fader start mode selection Fader Pause 27
Stereo/mono Selection of stereo or monaural playback Stereo 28
Pos Code Selection of whether or read Pos codes Pos OFF 29
Preset clear Setting for clearing presets and setting them to the initial values ' Init. Preset 30
Set information Microprocessor version display
Ver. **** (* = number)
31
NOTE:
For CDR discs without TOCs, there are no pits (signals) at the disc's lead in and lead out sections, so errors may occur, particularly when searching
for tracks. If an error should occur, open the disc holder, then close it and perform the operation again.
22
PRESET FUNCTIONS AND OPERATIONS
(1) List of Preset Functions
When presettings are made, the time display set with the TIME button, the play mode set with the PLAY MODE button and the finish mode set with the
FINISH MODE button at that time are stored in the memory. These modes will be set when the power is next turned on.