Denon AVR-682 Stereo Receiver User Manual


 
18
ENGLISH
NOTE:
When Small has been selected for the front speakers, Large cannot be selected for the surround speakers.
4
Use the (left) and (right) buttons to select your subwoofer setting.
4 S.WOOFER YES
YES
NO
(left) button (right) button
Press the SELECT or (down) button to enter the settings and switch to the SUBWOOFER MODE
setting.
Parameters
Large…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume. When this setting is
selected, low frequencies of below 80 Hz are assigned to the subwoofer.
None…… Select this when no speakers are installed.
Yes/No. Select Yes when a subwoofer is installed, No when its not installed.
NOTE:
Select Large or Small not according to the physical size of the speaker, but according to the bass reproduction capacity at 80 Hz. If you cannot
determine the best setting, try comparing the sound when set to Small and when set to Large, at a level that will not damage the speakers.
Caution:
In case the subwoofer is not used, be sure to set Subwoofer = No, or the bass sound of front channel is divided to subwoofer channel and
not reproduced in some mode.
Setting the SUBWOOFER MODE
1
Use the (left) and (right) buttons to select the Subwoofer mode.
5 SW MODE NORM
NORM +MAIN
(left) button (right) button
Press the SELECT or (down) button to enter the setting and switch to the SPEAKER DISTANCE
setting.
NOTES:
Assignment of low frequency signal range
The signals produced from the subwoofer channel are LFE signals (during playback of Dolby Digital or DTS signals) and the low frequency
signal range of channels set to SMALL in the setup. The low frequency signal range of channels set to LARGE are produced from those
channels.
Subwoofer mode
The subwoofer mode setting is only valid when LARGE is set for the front speakers and YES is set for the subwoofer in the Speaker
Configuration settings (see pages 17, 18).
If SMALL is set for the front speakers or NO is set for the subwoofer, the subwoofer mode setting does not affect playback of low
frequency signal range.
When the +MAIN playback mode is selected, the low frequency signal range of channels set to LARGE are produced simultaneously
from those channels and the subwoofer channel.
In this playback mode, the low frequency range expand more uniformly through the room, but depending on the size and shape of the room,
interference may result in a decrease of the actual volume of the low frequency range.
When the NORM playback mode is selected, the low frequency signal range of channels set to LARGE are only produced from those
channels. In this playback mode there tends to be little interference of the low frequency range in the room.
Try playing the music or movie source and select the playback mode providing the stronger low frequency range sound.
(Initial)
(Initial)