Filter
Top Products
ENGLISH
51
Advanced Setup – Part 2 Advanced Setup – Part 2
ENGLISH
• The Equalizer setting of “Normal”, “Flat” and “Front” can be
selected after performing the Auto Setup.
• When the speaker set as “None” with the Auto Setup is
change to on manually, the equalizer of “Normal”, “Front” and
“Flat” cannot be used.
• The Equalizer setting can be selected by SURROUND
PARAMETER button.
• When headphone is connected, the Room EQ cannot be used.
1
Press the CURSOR
DD
or
HH
button to select
“Direct Mode Setup” at the “Auto Setup/Room
EQ” menu, then press the ENTER button.
• The “Direct Mode Setup” screen appears.
Setting the Direct Mode Setup
Perform the ON/OFF setting of Room EQ when the surround
mode is “Direct” or “Pure Direct”.
2
Press the CURSOR
FF
or
GG
button to select “ON”
or “OFF”.
3
Press the ENTER button to enter the setting.
• The “Auto Setup/Room EQ” menu appears.
1
Press the CURSOR
DD
or
HH
button to select “EQ
Parameter Check” at the “Auto Setup/ Room
EQ” menu, then press the ENTER button.
• The “EQ Parameter Check” screen appears.
Check the EQ parameter
• The frequency characteristic of each speaker is rectified and
the tone of the speaker is unified.
• The EQ parameters that were set in Auto Setup can be
checked.
• This item is automatically displayed, after the measurement
result of the “Auto Setup/Room EQ” is decided.
2
Press the CURSOR
DD
or
HH
button to select the
equalizer curve, then press the ENTER button.
• The parameter screen appears.
3
Press the CURSOR
FF
or
GG
button to select the
speaker channel.
4
Press the ENTER button to enter the setting.
5
If the check ends, press the CURSOR
DD
or
HH
button to select “Exit”, then press the ENTER
button.
• The “Auto Setup/Room EQ” menu appears.
6
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the ENTER button.
• The “System Setup” menu appears.